Xerox DocuColor 6060 Operator's Manual page 288

P S
R O B L E M O L V I N G
6- 2 0
6
The Fuser area is on the right hand side of the Paper Transport module. Lift
handle 4c on the right hand side and pull to open.
7
Lift up handle 4d until it stops and clear any jammed paper. Rotate knob 4e in the
direction of the arrow on the knob to clear any paper that is caught.
NOTE:
Occasionally a sheet of paper wraps around the heat roll. (The heat roll
is visible when handle 4d is up). DO NOT attempt to remove this sheet of paper
because the stripper fingers may be damaged if you attempt this procedure. Call
your Xerox service representative to remove this piece of paper.
Reposition green handle 4d and close area 4c. Ensure these are firmly in place.
8
Grasp handle 4 and slowly push in the Paper Transport until it stops. Turn the
handle in the direction of the arrow to lock the module in place.
9
Close the Right and Left Front Doors.
10
Follow the instructions on the Touch Screen to restart your print job.
6 0 60
D O C U C O L O R O P E R A T O R M A N U A L