With Two Stackers - Xerox DocuColor 6060 Operator's Manual

A
C C E S S O R I E S
5- 1 8

With Two Stackers

To obtain a Sample Set, open the lid of the keypad on the HCS and press the #
key, then the 1 key. The system will complete the set being stacked, then send
the next set to the Top Tray.
KEY POINT:
A digital press fault may occur if you request a sample set in the
following situations:
• Requesting a sample set before the first sheet of a set reaches the Stack
Tray, or
• The output destination is other than the Stack Tray of the High Capacity
Stacker from which the request was programmed.
NOTE:
If Auto Tray Switching feature is not enabled, in Tools Mode, the button
for Both Stackers is not selectable. For detailed information on how to enable
this feature, refer to the DocuColor 6060 System Administration Guide.
1
Select the desired Output on the Basic Features screen.
• Stacker 1
• Stacker 2
• Both Stacker
2
Touch the Settings button on in the Output column of the Basic Features screen.
D C 6 06 0 O
O C U O L O R P E R A T O R
M
A N U A L