Paper Handling Difficulties; Print Quality Difficulties - Oce VL3200x User Manual

Paper handling difficulties

Difficulties
The machine does not load paper.
The LCD shows No Paper or a
Paper Jam message.
The machine does not feed paper
from the MP tray.
How do I print on envelopes?
What paper can I use?
There is a paper jam.

Print quality difficulties

Difficulties
Printed pages are curled.
Printed pages are smeared.
Printouts are too light.
Network difficulties
Difficulties
Cannot print over a wired Network. If you are having Network problems see the Network User's Guide for more
122
Suggestions
If there is no paper, load a new stack of paper into the paper tray.
If there is paper in the paper tray, make sure it is straight. If the paper is curled,
you should straighten it. Sometimes it is helpful to remove the paper, turn the
stack over and put it back into the paper tray.
Reduce the amount of paper in the paper tray, and then try again.
Check that the MP tray mode is not chosen in the printer driver.
If the LCD shows Paper Jam message and you still have a problem, see Paper
jams on page 140.
Fan the paper well and put it back in the tray firmly.
Make sure that MP tray mode is chosen in the printer driver.
You can load envelopes from the MP tray. Your application must be set up to print
the envelope size you are using. This is usually done in the Page Setup or
Document Setup menu of your application. (See your application's manual for
more information.)
You can use thin paper, plain paper, thick paper, bond paper, recycled paper,
envelops, labels and transparencies that are made for laser machines. (For
details, see Acceptable paper and other print media on page 15.)
(See Paper jams on page 140.)
Suggestions
Low quality thin or thick paper or not printing on the recommended side of the
paper could cause this problem. Try turning over the stack of paper in the
paper tray.
Make sure that you choose the Paper Type that suits the print media type you
are using. (See Acceptable paper and other print media on page 15.)
The Paper Type setting may be incorrect for the type of print media you are using,
or the print media may be too thick or have a rough surface. (See Acceptable paper
and other print media on page 15 and Basic tab in the Software User's Guide.)
If this problem occurs when making copies or printing received faxes, turn
Save Toner mode to Off in the machine menu settings. (See Save Toner
on page 28.)
Set Save Toner mode to Off in the Advanced tab in the printer driver. (See
Advanced tab in the Software User's Guide.)
Suggestions
information.
Make sure your machine is powered on and is on-line and in the Ready state. Print
the Network Configuration list to see your current Network settings. (See How to
print a report on page 83.) Reconnect the LAN cable to the hub to verify that the
cable and network connections are good. If possible, try connecting the machine
to a different port on your hub using a different cable. If the connections are good,
the lower LED of the back panel of the machine will be green.