Maytag AAV4000AW Series Service Manual page 11

Troubleshooting Procedures
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
All safety information must be followed as provided in the Service Manual.
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing.
EXIT SERVICE MODE
DISPLAY/CLEAR SERVICE CODES
CONSOLE SWITCH TEST
©2005 Maytag Services
All manuals and user guides at all-guides.com
!
CAUTION
!
WARNING
Rotate Cycle Selection Knob to "Power Off" and press
Allow 5 minutes of inactivity.
Disconnect power
Enter Service Mode then set Cycle Selection Knob to
"Rinse & Spin". Press knob
•
Rinse & Spin LED will blink if codes other than
power interrupt are present.
•
Press knob to view codes. Press once for each
code. Codes are displayed newest to oldest.
Machine beeps three times after last service code is
displayed.
•
To clear codes display a code then press and hold
Cycle Selection Knob until machine beeps twice.
Rinse & Spin LED stops blinking.
•
Refer to chart for Service Codes.
Enter Service Mode then set Cycle
Selection Knob to " Delicate " and press
•
Power Off LED blinks.
•
Pause and Delicates LED's are
illuminated.
Rotate the Cycle Selection Knob clockwise
for ascending, and counterclockwise for
decending test mode. Rotate 32 clicks in
the same direction to complete the test.
16026502
knob.
or
or
knob.
11