Maytag AAV4000AW Series Service Manual page 70

Using the Controls –
STEP 5
Soak Only
(select models)
Provides approximately 33 minutes of alternating
periods of soaking with brief agitation at slow speed.
At the end of the cycle, the Cycle Selector dial must be
manually set to a wash cycle or spin cycle to drain the
washer. Avoid extended soaking.
Spin Only
Provides a spin to remove more water from the load.
Rinse and Spin
Use for loads that need rinsing only or to add rinse-
added fabric softener to a load.
Power Off
To cancel the cycle and turn off the washer, turn the
Cycle Selector dial to Power Off and push the dial in.
11
B–30
All manuals and user guides at all-guides.com
Electronic Control Models
Select Options
Extra Rinse
When the knob is in the On position, an
additional rinse at the end of all cycles
is provided to more completely remove
laundry additives, suds, perfumes, etc.
End of Cycle Signal
The end of cycle signal will sound once the
cycle is completed. On select models, the
end of cycle signal can be canceled by
setting the switch to Off.
Start the Washer
To start the washer, press the cycle selector dial.
Changing a Cycle
If an incorrect cycle has been accidentally
selected:
1. Press the cycle selector dial.
2. Turn the cycle selector dial to the desired cycle.
3. Set the desired options for the cycle.
4. Press the cycle selector dial. The Wash indicator
Canceling a Cycle
To cancel a cycle:
1. Press the cycle selector dial.
2. Turn the cycle selector dial to Power Off and push
To drain the washer:
1. Select the Rinse and Spin or Spin Only cycle.
2. Press the cycle selector dial. The Spin light
16026502
STEP 6
STEP 7
lights stop flashing and the new cycle starts.
the dial in.
illuminates and the washer starts the rinse or spin.
©2005 Maytag Services