These settings feature Automatic
Saves energy by adding cold water
to the hot water from your water
heater. Provides optimum cleaning
at lower temperatures.
May add hot water to the incoming
cold water as the washer fills. This
assures that the water will be warm
enough to properly activate detergent.
In wash water temperatures below 60
detergents do not dissolve well or clean well.
To select a cycle, push the control dial in and turn it to
the right (clockwise) until the pointer is at the number
of minutes desired for the wash load.
IMPORTANT: For optimum fabric care, the
appropriate wash and spin speed for the load type
must be selected using the Wash/Spin Speed knob.
Regular/Delicates cycles share the same portion of the
control dial. For regular fabrics, select the cycle and
turn the Wash/Spin Speed dial to Normal/Normal. For
delicate loads, select Slow/Slow.
©2005 Maytag Services
All manuals and user guides at all-guides.com
Wrinkle-Free Clothes Cycle
This cycle provides up to 12 minutes of agitation.
Depending on the load, select either the Normal/Slow
or Slow/Slow wash/spin speed.
Stain Cleaner Cycle
Stain Cleaner provides approximately 30 minutes of
agitation and soaking to help remove stubborn dirt and
stains. For more information see page 8.
Select Extra Rinse
When the switch is in the On position, an additional
rinse at the end of the Regular/Delicates cycle is
provided to more completely remove laundry additives,
suds, perfumes, etc.
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial in. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.