Current Out Set Up Group
Table 15 lists the parameters and selections available for the SET CUROUT group.
Actuator Lower
Display
Prompt
CUROUT
Note : If output
type from model
selection guide
is:
0/4-20mA, 0/1-
5Vdc
CUROUT
Note : If output
type from model
selection guide
is:
Slidewire
Emulation
CUROUT
Note : If output
type from model
selection guide
is:
None
Revision 6
HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/07
Table 15 Current Out Set Up Group Parameters
Selections or
Range of Setting
OUTPUT SIGNAL RANGE — Selects the signal output
range.
4 – 20
4 to 20 mA
0 – 20
0 to 20 mA
1 – 5V
1 to 5 Volts (250 ohm resistor required)
0 – 5V
0 to 5 Volts (250 ohm resistor required)
SW E
Slidewire Emulation
NONE
No current output configured.
Set Up and Calibration Procedures
Parameter Definition/PDA HercuLink Prompt
Current Out Set Up Group
49