Installation; Installation Overview - Honeywell 2000 Series Installation, Operation And Maintenance Manual

Installation

Installation Overview

Installation Overview
The procedures to install the HercuLine
•
Select a suitable location for installation. (See Installation Considerations below.)
•
Mount the actuator securely.
•
Install mechanical connections or linkage between control arm and final control element. Use HAL software
application to aid in mechanical installation.
•
Make all electrical connections for actuator according to local and national electrical codes.
•
Power up actuator.
•
Enter, verify and adjust set up parameters for proper operation.
•
Adjust control arm linkage for accurate operation of final control element.
This section provides you with mechanical and electrical installation information required to mount and connect
®
the HercuLine
consisderations, electrical and safety precautions also included in this section should be observed.
Mechanical Stops
Factory set at 90° or 150° (+/-5°).
See Figure 2 for location.
Attention: Do not adjust the mechanical Stops. Adjusting the stops will void the warranty
12 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
®
2000 Series Actuator to your specific application. Unpacking instructions, installation
Installation
2000 Series actuator and place it in service require that you:
Revision 6
7/07