Set Up and Calibration Procedures
Display Set Up Group
Display Set Up Group
Table 18 lists the parameters and selections availible for the SET DISPLAY group.
Actuator Lower
Display
Prompt
DECMAL
EUNITS
UNITS
52
HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
Table 18 Display Set Up Group Parameters
Selections or
Range of Setting
DECIMAL POINT LOCATION — This selection determines
where the decimal point appears in the display.
8888
None
888.8
One Place
Note: Be sure the selection agrees with the value to be
displayed. If display value requires 4 whole digits, the
default = 8888
decimal will not show.
UNITS DISPLAY — Selects the units of the position display.
Percent — Shows actuator position as a percentage of span.
PCNT
(0 to 100%)
Degrees — Shows the actuator position in degrees of
DEG
rotation. (0 to 150 ° ) (90 ° )
default = PCNT
DISPLAY UNITS — Selects standard for unit values for the
local display.
SI — Display will show unit values in international (metric)
SI
units. (Temperature in degrees C, Date format: ddmmyy)
English — Display will show unit values in U.S. units.
ENGL
(Temperature in degrees F, Date format: mmddyy)
default = ENGL
Parameter Definition/PDA HercuLink
®
Prompt
Revision 6
7/07