Rear Brake Adjustment; Front Brake Pad Inspection And Replacement - Yamaha YZ85( P) /LC Owner's Service Manual

FRONT BRAKE PAD INSPECTION AND REPLACEMENT

È

REAR BRAKE ADJUSTMENT/

5PA30330
5PA30340
É
5PA30350
5PA30360
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
Brake pedal height a
Out of specification
Brake pedal height a:
7 mm (0.28 in)
2. Adjust:
Brake pedal height
Pedal height adjustment steps:
Loosen the locknut 1.
Turn the adjusting nut 2 until the pedal
height a is within specified height.
Tighten the locknut.
WARNING
Adjust the pedal height between the
maximum È and the minimum É as
shown. (In this adjustment the bolt 3
end b should protrude out of the lower
adjusting nut 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
After the pedal height adjustment, make
sure that the rear brake does not drag.
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Remove:
Rubber cap
2. Inspect:
Brake pad thickness a
Out of limit
Brake pad thickness:
4.0 mm (0.16 in)
<Limit>: 0.8 mm (0.03 in)
3 - 18
INSP
ADJ
Adjust.
Replace as a set.