Turboramtest - Brocade Communications Systems Brocade 8/12c Command Reference Manual

2

turboRamTest

turboRamTest
Performs a turbo SRAM test of ASIC chips.
Synopsis turboramtest [--slot slot][-passcnt count]
ceeturboramtest [--slot slot][-passcnt count]
Description Use this command to verify the chip SRAM located in the ASIC using the turbo-RAM BIST circuitry.
The BIST controller is able to perform the SRAM write and read operation at a much faster rate
than the PCI operation.
The turboRamTest and ceeTurboRamTest commands are platform-specific versions of the same
test. The turboRamTest command is supported on all Goldeneye/Goldeneye2 and
Condor/Condor2 platforms. Use ceeTurboRamTest on FCoE platforms only. On all other supported
platforms, use turboramtest. Refer to the Fabric OS Troubleshooting and Diagnostics Guide,
Appendix A, for a table that correlates ASIC type with switch models.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
The switch must be disabled before you can run this diagnostics.
Operands This command has the following optional operands:
--slot slot
-passcnt count
Examples To run the SRAM test with two passes:
To run the SRAM test on a Brocade 8000 in default mode:
See Also none
986
Specifies the slot number on which the diagnostic operates. All eligible blade
ports in the specified slot are tested. This operand is optional. The default
value is 0 and operates on fixed port count products.
Specifies the number of times to perform this test. This operand is optional.
The default value is 1.
switch:admin> turboramtest -passcnt 2
Running turboramtest ..............
PASSED.
switch:admin> turboramtest
Running turboramtest ..............
PASSED.
Fabric OS Command Reference
53-1001764-01