Brocade Communications Systems Brocade 8/12c Reference page 41

TABLE 5
Detailed description of the commands
Command
snmpConfig --show | --set | --default |
--enable | --disable [snmpv1 | snmpv3
| accessControl | mibCapability |
systemGroup | seclevel]
Fabric OS MIB Reference
53-1002151-01
Operands
--show
Displays the SNMP agent configuration data of
the specified category.
--set
Sets the SNMP agent configuration data of the
specified category. This operand displays the
current settings and then prompts you to
change the values for each parameter.
--default
Sets the SNMP agent configuration data for a
specified item to the default values. Generally,
these default values may be available in the
configuration database. The command sets to
factory defaults if the SNMP agent configuration
parameters are not available in the
configuration database.
--enable
Enables the SNMP agent configuration for the
specified category. This operand is
valid only with mibCapability and snmpv1. When
used with the snmpv1
operand, this command restores access to
SNMPv1/v2c.
--disable
Disables the SNMP agent configuration for the
specified category. This operand is valid only
with mibCapability and snmpv1. When used
with the snmpv1 operand, this command blocks
access to SNMPv1/v2c. All requests for v1/v2c
version will be dropped by the switch, and
SNMPv1 traps will be blocked from being sent,
even if trap destinations are present.
Fabric OS commands for configuring SNMP
Arguments
snmpv1 Selects SNMPv1-related configuration
parameters. These parameters include the
community string, trap recipient IP address,
and trap severity level associated with each
trap recipient IP address. When "0" is
configured as a trap port, traps can be received
at the default port 162.
snmpv3 Selects SNMPv3-related configuration
parameters. These parameters include the
user name, authentication protocol and
password, the privacy protocol and password,
the SNMPv3 trap recipient's IP address, its
associated user index and trap severity level.
When "0" is configured as a trap port, traps can
be received at the default port 162. In Fabric
OS v6.3.0 and later, the --set snmpv3
command supports an interactive option to
enable or disable informs by setting the
parameter "SNMP Informs Enabled" to true or
false. If informs are enabled, all trap
destinations receive inform requests. If informs
are disabled, all trap destinations receive trap
requests. When informs are enabled, the
engine ID must be set to correspond to the
management engine IP address. Informs are by
default disabled.
accessControl Selects access-control-related
parameters. These parameters include the
access host subnet area and access
permission (read-write).
mibCapability Selects configuration
parameters related to the SNMP agent's MIBs
and trap capability parameters. These
parameters include MIBs and traps supported
by the SNMP agent.
systemGroup Selects configuration parameters
related to the system group. These parameters
include sysDescr, sysLocation, sysContact, and
authentication failure trap.
secLevel Sets the SNMP security level.
1
21