Table of Contents
Advertisement
Client Address
Restrictions may be imposed on clients accessing
the camera using the IP address.
Access Restriction
Deny:
0
Denies acquisition of H.264/JPEG or audio
transmission data from the IP address specified
in [IP Address]. Restrictions are not imposed on
access to the setting page.
Allow:
0
Accepts acquisition of H.264/JPEG or audio
transmission data from the IP address specified
in [IP Address]. Restrictions are not imposed on
access to the setting page.
[Set values: RDeny, Allow]
IP Address
You can register up to 10 IP addresses for
prohibited or permitted clients.
Memo :
To specify a specific IP address range, enter a
0
combination of the IP address and subnet mask
in the [IP Address] item.
Define the subnet mask using a length between
0
8 to 30 bits.
For example, to specify the range from
192.168.0.0 to 192.168.0.255, 192.168.0.0/24
([IP address]/[bit length of subnet mask]) is
used.
Note :
Note that when "Allow" is selected and all IP
0
address fields are left blank, acquisition of H.
264/JPEG or audio transmission data from all IP
addresses will be denied.
Restrictions are not imposed on access to the
setting page.
Additionally, the camera will also deny access
when instructions for transmission to the
specified IP address are sent via API.
[Time] Page
This page sets the current clock time.
This page can be used during access using
"admin".
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Memo :
The time of the internal clock may be
0
significantly out of alignment if the power of the
product is turned off for a long time or when there
is prolonged power failure. If this occurs,
readjust the [Time] setting.
Settings
.
* Setting values with R are default values.
SNTP
Sets the SNTP client function.
ON:
Gets the time by periodically accessing the
specified NTP server.
OFF:
Does not access the NTP server.
[Set values: ROFF, ON]
Memo :
The time is recorded in the JPEG header and
0
H.264 header distributed by the camera. The
time recorded in the JPEG header and H.264
header may be discontinuous immediately
before and after acquiring the time from the NTP
server.
[Advanced Settings] Page -[Access Restrictions] Page
79
Advertisement
Table of Contents
