Table of Contents
Advertisement
Port Number
Input the port number.
[Set values: 0 to R25 to 65535]
Send Mail Address
Specify the sender's mail address.
POP before SMTP
To enable [POP before SMTP], select "Enable" and
set the POP server.
[Set values: RDisable, Enable]
9 POP Server
For setting the IP address or FQDN of the POP
server.
9 Port Number
Input the port number.
[Set values: 0 to R110 to 65535]
9 User Name
Enter the user name.
9 Password
Enter a password.
Alarm Output
Configure settings related to alarm output from an
alarm output cable or connector.
Duration
Set the output duration for [Manual Output].
[Set values: R0, 100 to 5000] msec
Manual Output
Manually operate alarm output.
The current output status is displayed on the right
side. When [Duration] is set to "0", pressing the
[Make] button sets the alarm to make output, and
pressing the [Break] button sets the alarm to break
output.
When [Duration] is set to other than "0", pressing
the [Make] button sets the alarm to make output
only for the output duration time, and then changes
it to break output.
When [Duration] is set to other than "0", pressing
the [Break] button sets the alarm to break output
only for the output duration time, and then changes
it to make output.
[Set values: Make, RBreak]
[Advanced Settings] Page - [Alarm Environment] Page
60
[FTP Recording] Page
This page describes setting procedures related to
recording.
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Record Status].
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Options displayed vary according to the
0
recording mode selected.
Memo :
If FTP recording is set while [microSD Card
0
Recording] is set to "ON", a dialog box will
appear. When this occurs, press the [OK] button
to set [Record Status] of [microSD Card
Recording] to "OFF".
Settings
.
* Setting values with R are default values.
Advertisement
Table of Contents
