Table of Contents
Advertisement
Caution
To supply power to this product, make use of AC
24 V 50 Hz/60 Hz or PoE Plus (IEEE802.3at
Type2). Make use of the correct voltage.
Be sure to use an AC 24 V supply that is isolated
from the primary power supply circuit.
Supplying a power beyond the rated value may
result in failures, smoke or fire. If the camera
breaks down, turn off the power and contact your
dealer immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on the
appearance and operation of the camera.
Please contact your dealer immediately for
servicing (charged separately).
5 Connect the LAN cable.
Connect the hub or computer to the LAN
0
cable connector of the camera with a LAN
cable.
When connecting to a hub: Make use of a
0
straight cable.
When connecting to a computer: Make use
0
of a cross cable.
Wind the connector section with waterproof
0
tape (adhesive) and push the LAN cable into
the arm of the camera.
Wind the waterproof
tape (adhesive)
.
LAN cable to use
STP (Recommended shield cable)
0
Length of 100 m or shorter
0
Category 5e and above
0
Note :
Connect to an AC 24 V power supply when using
0
the VN-H657WPBU in an environment below
-10 °C. When power is supplied using PoE Plus,
the heater will not work.
Cross cables cannot be used with some
0
computers. When connecting the camera
directly to a computer, check the computer's
LAN specifications in advance.
Mounting the Camera (VN-H657WPBU)
36
Arm
LAN Cable
Connector
6 Connect the alarm signal cable.
Connect the alarm signal cable to external
0
devices, such as a sensor or buzzer.
For information on the color and signal name
0
of the alarm signal cable, refer to the
following.
(A p.16 [List of Alarm Signal Cable Signals] )
Fore more details on alarm input/output,
0
refer to the following.
(A p.19 [Alarm Input/Output Signal] )
After connecting the alarm signal cable, wind
0
the waterproof tape (adhesive).
After connecting, push the alarm signal
0
cable into the arm of the camera.
Wind the
waterproof tape
(adhesive)
.
Alarm signal cable to use
Length of 50 m or shorter
0
UL1007, UL1015 or equivalent products
0
AWG#22 to AWG#18 or equivalent
0
products
Note :
For cables that are not used, be sure to wrap the
0
ends individually with waterproof tape
(adhesive) to ensure that waterproof treatment
is performed.
For safety reasons, turn on the power only after
0
ensuring that all the connections are in place.
Noises from an external source may cause the
0
camera to malfunction even when the cable
used is within 50 m. In this case, move the cable
away from the noise source.
Solder welding or
crimping
Insulating tape
Advertisement
Table of Contents
