Table of Contents
Advertisement
EncoderNo.4
For setting manual distribution by EncoderNo.4.
Destination Address
For specifying the destination address for audio
distribution.
Specify the multicast address. When other devices
that make use of multicast transmission exist,
ensure that each of them is set to a different
multicast address.
[Factory default: 225.0.3.1]
Destination Port
For specifying the destination port number for
audio distribution.
Specify an even number for RTP compliance.
When other devices that make use of multicast
transmission exist, it is recommended that each of
them be set to a different port number.
Multiple multicast streams cannot be received on
a single computer when there are duplicate port
numbers.
[Factory default: 39152]
Start
Saves the [Destination Address] and [Destination
Port] settings, and starts manual distribution.
It is displayed as a [Stop] button during distribution.
[Destination Address] and [Destination Port]
cannot be changed while distribution is in progress.
[Advanced Settings] Page - [Multicast] Page
78
[Access Restrictions] Page
This page is for setting client restrictions.
This page can be used during access using
"admin".
Click [Advanced Settings] in the side menu, and
0
click [Access Restrictions].
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Memo :
This feature is applicable for restricting the
0
acquisition of H.264/JPEG or audio
transmission data. It does not impose
restrictions on access via a web browser or use
of API.
Note :
The Access Restriction feature determines
0
whether to impose restrictions during TCP
connection by the client. In the case when
access restriction is set after TCP connection by
a client has been established, TCP connection
will not be disconnected.
Settings
.
* Setting values with R are default values.
Advertisement
Table of Contents
