Table of Contents
Advertisement
SNTP Server
Sets an IP address of NTP server.
[Factory default: 0.0.0.0]
Interval
Sets a unit and values of measurement for the time
interval at which to access the NTP server.
[Set values: Min(1-60), RHour(1-24), Day(1-31)]
Time
Displays the clock time of camera.
You can correct the time by entering a value
(without seconds).
Memo :
The time is recorded in the JPEG header and
0
H.264 header distributed by the camera.
Discontinuity may occur in the time of the JPEG
header and H.264 header immediately before
and after changing the time.
Change the [Time] if it does not coincide with the
0
[Time Zone] of the region you are residing.
Time Zone
Sets a time zone.
[Set values: (GMT-12:00) to R(GMT)UTC to (GMT
+12:45)]
Memo :
After changing the [Time Zone], check to ensure
0
that the [Time] is correct. If it is incorrect, readjust
the [Time] accordingly.
Note :
When the [Time Zone] settings are changed to
0
a value different from the factory default, they
cannot be restored to the factory settings even
by initializing using [All Settings] on the
[Maintenance] page.
(A p.81 [[Maintenance] Page] )
PC Time to Camera
Click [Set] to set the computer's time on the
camera.
[Advanced Settings] Page - [Time] Page
80
[Password] Page
This page sets a password.
This page can be used during access using
"admin".
Note :
Be sure to handle the password carefully in case
0
you forget it.
If you have forgotten the password, please
0
consult your dealer.
Settings
.
Advertisement
Table of Contents
