[Alarm] Page - JVC VN-H657WPBU Instructions Manual

Jvc hd ip ptz camera
Hide thumbs Also See for VN-H657WPBU:
Table of Contents

Advertisement

Upload
Audio File No.1 to No.5
For registering the audio file to be output from the
camera's audio cable or terminal when an alarm is
activated.
To display the file selection screen and select an
0
audio file prepared in advance, press the
[Browse...] button.
To register the selected audio file to the camera,
0
press the [Upload] button.
To delete an audio file registered to the camera,
0
press the [Delete] button.
To play back an audio file registered to the
0
camera and output it to the audio cable of the
camera, press the [Play] button.
To stop playback of an audio file, press the
0
[Stop] button.
Memo :
You can record audio or create a file in the WAV
0
format using the sound recorder of Windows or
generic audio processing tools.
How to output a registered audio file
A Get ready an audio file with the following
specifications on your computer, and register
it to the camera.
File format: WAV
0
Encoding system: linear PCM
0
Sampling frequency: 8 kHz
0
Quantization bit: 16 bits
0
Monaural
0
Maximum size: 30 seconds
0
B Set the [Action] item on the [Alarm] page to
"Play Audio".
Memo :
For details about the alarm settings, refer to
0
the [Alarm] page.
(A p.56 [[Alarm] Page] )
Note :
If the audio transmission function of the
0
Built-in Viewer is activated while playing an
audio file, playback of the file will stop.
Audio files cannot be played back while the
0
audio transmission function of the Built-in
Viewer is running.
[Advanced Settings] Page - [Audio] Page
56

[Alarm] Page

This page sets actions to be taken if an alarm
occurs. You can set up to five actions (No. 1 to No.
5).
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Alarm].
Press the [OK] button to enable the new
0
settings. Only items that are valid under the
selected [Action] will be saved. If you set an
[Action] to "Disable", its settings are initialized.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
The contents displayed changes depending on
0
the selected action and the item of [1st Trigger].
Settings
.
* Setting values with R are default values.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vn-h657bu

Table of Contents