Table of Contents
Advertisement
9 Trigger1, Interval, Trigger2
Trigger1:
0
For selecting the first trigger for performing
alarm recording.
[Set values: RPin Input1 Make, Pin Input2 Make,
Pin Input1 Break, Pin Input2 Break, Position,
Audio Detection1, Audio Detection2, Motion
Detection, Tampering Detection, Time, Day/
Night, FAN Stop]
Interval:
0
Specify the maximum interval between each
trigger for [Trigger1] and [Trigger2].
[Set values: 1 to 3600]
Trigger2:
0
For selecting the second trigger for performing
alarm recording.
[Set values: RDisable, Pin Input1 Make, Pin
Input1 Break, Pin Input2 Make, Pin Input2
Break]
9 Position Number
Displayed when "Position" is selected in [Trigger1].
Executes alarm recording upon moving to the
entered preset position.
[Set values: 0 to 99]
Memo :
Specify the setting for Preset Position in [PTZ
0
Settings] of Built-in Viewer.
(A p.94 [ [PTZ Settings] ] )
9 Day/Night
This is enabled when "Day/Night" is selected for the
[Trigger1] item.
Color:
0
Executes alarm recording when the image
switches from black-and-white to color.
Black & White:
0
Executes alarm recording when the image
switches from color to black-and-white.
[Set values: Color, Black & White]
9 Time
Displayed when "Time" is selected in [Trigger1].
Executes alarm recording at the time you have
entered.
[Set values: 00H00M to 23H59M]
[Advanced Settings] Page - [FTP Recording] Page
62
9 Pre-Trigger
For setting the FTP pre-recording trigger time
(recording time before alarm input) in seconds.
[Set values: 0 to R5 to 60]sec
9 Post-Trigger
For setting the FTP post-recording trigger time
(recording time after alarm input) in seconds.
[Set values: 0 to R5 to 60]sec
Memo :
[Pre-Trigger] and [Post-Trigger] cannot be set to
0
"0 sec" at the same time.
To keep only one image at the time of alarm
0
occurrence, set [Pre-Trigger] or [Post-Trigger]
to "1 sec", and [Encoder] of [Alarm] to "1 fps".
9 Sunday to Saturday
For selecting whether to activate or stop recording
by day of the week.
[Set values: RUnmask All, Mask All, Unmask
Span, Mask Span]
For setting the time period when "Unmask
0
Span" or "Mask Span" is selected.
[Set values: 00H00M to 24H00M]
Advertisement
Table of Contents
