Table of Contents
Advertisement
Auto Trace
For setting Auto Trace. This item stores and
reproduces manual operations of the camera.
Click [Auto Trace] in the operation menu to open
0
the setting screen.
As Auto Trace performs simple saving of manual
0
operation, the position may be slightly
misaligned during playback.
Digital Flip in [Auto Flip] cannot be used during
0
Auto Trace recording.
.
[Control] - [PTZ Settings]
96
State
[Record Start]:
0
The camera will start recording of Pan/Tilt and
Zoom operations. (for approximately 30
seconds)
[Record Stop]:
0
Click this when a recording operation is
complete.
Memo :
For details on manual pan, tilt, and zoom
0
operations, refer to the following.
(A p.98 [ Pan / Tilt / Zoom ] )
9 [State] Display
The current status is displayed.
Standby:
0
The camera is on standby. [Record Stop] is
invalid.
Recording:
0
The camera is recording. Click [Record Stop] to
finish recording. "Completed" will be displayed.
Completed:
0
Recording is completed. After "Completed" is
displayed for three seconds, "Standby" will be
displayed.
Timeout:
0
30 seconds has passed since recording started.
(Operation for the 30 seconds has been
recorded.) After "Timeout" is displayed for three
seconds, "Standby" will be displayed.
Memory Full:
0
The operation has exceeded the number of
recordable operations. Further recording
cannot be made even if it is within 30 seconds.
(Operations before the limit are recorded.) After
"Memory Full" is displayed for three seconds,
"Standby" will be displayed.
Advertisement
Table of Contents
