Table of Contents
Advertisement
4 Pull the cables from the hole in the
wall.
Pull the power cable, LAN cable, alarm
0
signal cable, and audio cable from the wall.
.
Setting Up the Camera
1 Remove the dome cover.
Loosen the screws (x4) and remove the
0
dome cover from the camera.
Dome cover
.
2 Remove the lens cap and tape used
during transporting.
Tape
Lens cap
.
Memo :
When installing the heater at an unrequired
0
location, turn off the ON/OFF switch of the
heater.
Installation and Connection Preparations (VN-H657WPBU)
32
3 Insert the silica gels.
A Loosen the screw and lift up the clamp.
B Take out three silica gels from the aluminum
LAN cable
Power cable
Alarm signal
C Fix the silica gels firmly with the clamp, and
cable
Audio Cable
Heater
.
Memo :
0
0
Heater ON/OFF
Note :
switch
0
OFF
0
Be sure to insert the provided silica gels in
0
the position as shown in the diagram.
bag, and insert them into the back of the heater
(as shown in the diagram).
After inserting the silica gels, check that they
0
are not touching the heater.
fasten the screw.
Turn the clamp until the silica gels are
0
secured, followed by tightening the screw.
Heater
Screw
Fasten the silica gels firmly
with the clamp
During reconnection or re-installation after
repair or maintenance, make sure to replace the
silica gels with new ones.
Consult your dealer on the replacement
procedures. Use the silica gel with a service part
number of LW40500-001A for the part to be
replaced.
If silica gel is not inserted, the camera lens and
dome cover may turn foggy, and the camera
image may not turn out clear.
When installing on a rainy day, ensure that
raindrops do not enter the interior.
Clamp
Silica gel
x3
Clamp
Advertisement
Table of Contents
