Table of Contents
Advertisement
Removing the dome cover
1.
Remove the dome cover
Loosen the dome cover fastening screws (x3)
with the wrench (supplied) and remove the dome
cover.
Memo ：
● The dome cover is connected to the base via
a fall-prevention wire.
Fall-prevention
wire
2.
Remove the inner dome
The inner dome is secured by 3 claws. Remove
the inner dome from the claws.
Note ：
● Make sure you touch the metal surface of the
[MONITOR] terminal to release the static
electricity from your body. Static electricity
may cause the camera to malfunction.
Claw
(3 locations)
Wrench (Supplied)
Inner
dome
Mounting the base
Remove the camera unit from the base and
mount the base to the ceiling or wall.
To mount on a wall, use the same procedures
below but replace the word "ceiling" with "wall".
Setup
If necessary, use the attached template to drill
a hole (R30 mm, 1-1/8 inches) for mounting.
(1-1/8 inches)
Fall-prevention wire
(not attached)
Power cable,
alarm cable,
heater cable
LAN cable
1.
Remove the camera unit from the base
A
Loosen the camera fastening screws (x2)
with the screw driver.
B
Remove the camera from the base while
pressing in the two claws.
B
Claw
(2 locations)
Camera unit
Base
R30 mm
Approx. 100 mm
(3-7/8 inches)
A
17
Advertisement
Table of Contents
