Pager Delay Time; Program Address (4038); Programmer's And Master Code Programming: Program Addresses (7589-7592); Pin Length Programming - Bosch DS7400Xi Reference Manual

10.33 Pager Delay Time: Program Address (4038)
When using the Pager Dialing Format (selected in Addresses 3156 and 3157), you may insert a delay time after the phone number is
dialed and before the reports are sent to the pager system. This delay can be used to allow for greeting and instruction messages in the
pager system. This delay will not affect any other report formats.

10.34 Programmer's and Master Code Programming: Program Addresses (7589-7592)

Programmer's Code programming defines what the Programmer's Code will be. This code is used to enter the programming mode
from the keypads.
Although the DS7400Xi (Ver. 4+) Control/Communicator is shipped with 6-digit codes preprogrammed, it is also shipped
with a 4-digit PIN length default. The default codes for the Programmer's Code and the Master Code will be 4-digits (9876
and 1234 respectively) unless you have reprogrammed for a 6-digit PIN length.
Programmer's Code
Enter as 6 digits.
It can not be the same
as any PIN number.
The Default for the Programmer's Code = 987654
Master Code programming defines what the Master Code will be. This code is the highest authority level for a PIN.
If the Master Code is lost, this address may be used to program a new one.
Otherwise, the Master Code Programming Mode should be used to create PINs
that have a Master Code authority level.
Master Code for User Number 001 has its
authority fixed at level 0. It will always have
access to all partitions.
NOTE: User Numbers 002 through 200
must be programmed from the
Master Code Programming
Mode.
10.35 PIN Length Programming: Program Address (3478)
PIN Length Programming defines the length of the PINs that are assigned to each user.
PINS can be programmed to be 4 or 6 digits in length.
DS7400Xi ( 4+) Reference Guide

Pager Delay Time

Address 4038
0 to 99 seconds
Program Address 7589
Data Digit
1 2 3
9 8 7
Master Code PIN Number
(Default for this User 001
is 123456)
Copyright © 2007 Bosch Security Systems, Inc.
Data Digit
1 2
Default = 10 seconds
4 5 6
6
5 4
Program Address 7592
1 2
1
2
Select Option
4-digit PINs 0
1
6-digit PINs
Data Digit
3 4 5
3 4 5
Data Digit
1 2
0
P/N: F01U035325-01 Page 59
6
6