Follow Zone: Program Addresses (2740-2771) - Bosch DS7400Xi Reference Manual

10.36 Octal Relay Module Output Programming (continued)

10.36.4 Follow Zone: Program Addresses (2740-2771)

To program an Octal Relay Module for Follow Zone, follow the steps below.
1. Select Octal Relay to program.
2. Program Data Digit 1 of Program Address A as 4 for Follow Zone.
3. Program Data Digit 2 of Program Address A for the desired function.
4. Program Data Digit 1 and 2 of Program Address B for the desired zone.
Once both Address A and Address B have been programmed, proceed to program the next Octal Relay.
0 1
Activate:
Disabled
When zone is shorted
When Zone is opened
When panel is Armed
When panel is not Armed
Latch when activated**
** = This applies only to the DS7465 outputs.
DS7488 outputs will not latch when this is selected.
DS7400Xi ( 4+) Reference Guide
Program Address A
Data Digit
1 2
4
SELECT OPTION DD 2
2 3 4 5 6 7 8 9 *0 *1 *2
Copyright © 2007 Bosch Security Systems, Inc.
Octal DS7488-1 DS7488-1
Relay Address Address
# A B
1 2740 2741
2 2742 2743
3 2744 2745
4 2746 2747
5 2748 2749
6 2750 2751
7 2752 2753
8 2754 2755
9 2756 2757
10 2758 2759
11 2760 2761
12 2762 2763
13 2764 2765
14 2766 2767
15 2768 2769
16 2770 2771
Program Address B
Data Digit
1 2
Program the HEX value
of the Zone
from the chart
on the next page
P/N: F01U035325-01 Page 63