Resetting The Bios - Gateway E-9525R User Manual

CHAPTER 5: Using the BIOS Setup Utility

Resetting the BIOS

68
Remove the jumper across pins 1-2 of header J3-E, then place the jumper
3
across pins 2-3.
Follow the instructions in
4
Insert a bootable USB "disk-on-key" containing a valid BIOS image into a
5
USB port.
Reconnect the power cords and turn on the server. The BIOS recovery is
6
initiated.
While the BIOS is being recovered, the monitor displays a blue screen and
7
the server will beep continually. The process is complete when the server
stops beeping.
Remove the bootable USB "disk-on-key. "
8
Turn off the server, then disconnect the power cords and all other cables
9
connected to the server.
Follow the instructions in
10
Place the jumper back onto pins 1-2.
11
Follow the instructions in
12
Plug in the AC power cords and turn on the server, then verify that the
13
recovery was successful.
You can use two methods to clear all BIOS Setup settings and return them to
the factory defaults:
Press the power and reset buttons on the front of the server.
■
Move the Clear CMOS jumper on the system board.
■
"Closing the server case" on page
"Opening the server case" on page
"Closing the server case" on page
www.gateway.com
32.
31.
32.