Table of Contents
Advertisement
Zeta Alarm Systems.
Remote LEDs can be configured to annunicate the following:
Global System Info
AC Power OK - This remote LED will be turned on when AC power is present. It is hard-
mapped to LED #1.
AC Power Fail - This remote LED will be turned on when AC power is absent. It is hard-
mapped to LED #2.
Offline - This remote LED will be turned on when the panel is offline. It is hard-mapped to
LED #3.
Input Point Annunication
Each input point may be mapped to two remote LEDs, each of which may annunciate either an
alarm or trouble condition. The LED assignments are made in the Point Configuration menu.
Output Group Annunciation
Each output group may be mapped to two remote LEDs. The first LED annunciates the state of the
inputs assigned to the group, while the second LED annunciates the state of the outputs assigned
to the group. Normally, these two LEDs come on at the same time; the only situation in which they
will not is when the panel uses the floor-above/floor-below capability of the panel, in which case a
group's outputs may be activated regardless of whether or not the group's inputs are activated.
The LED assignments are made in the Configure Groups menu.
Each driver has a "base LED number", which is set during system configuration. This number sets
the first LED (or relay) number that will be annunciated from that device. For example, if an ZRLD
has a base LED number of "1", it will be able to annuciate LEDs 1-30 (or 1-60 if an ZRLD expander
is installed). If more than one driver has the same base LED number, they will display identical
information.
Note: The "special" output groups may be used to annunciate system-wide conditions:
Output Group 99 = General Alarm
Output Group 98 = General Trouble
Output Group 97 = General Supervisory
Output Group 96 = General Waterflow
Revision 1.0
Classic 2000 Mk II Operation Manual
Part # MAN-Z3K-01
Page 73
Advertisement
Table of Contents
