Table of Contents
Advertisement
Zeta Alarm Systems.
Press 1.
To edit point address. Enter 0-9 for the loop and 1-127 for the address. The first line
will include a 5-character device type abbreviation.
Press 2.
To edit the point entered in 1 above.
Press 3.
To browse through the points.
Press 4.
To change device status. Pressing will toggle between enabled/disabled.
Press 5.
To auto-program the panel.
Press 6.
To view previous loop.
Press 7.
To see next loop.
Press 0
In edit and browse menus to toggle between: "view only installed points" and "view all
points"
Press ENTER to edit the specified point.
Press ESC to exit the screen.
Each time a change is made in programming the system, SLC, or Network devices (adding,
deleting), you must rescan the loops (Auto-Program).
4 . 2 . 6 . 1 A u t o - P r o g r a m
When Auto-Program is utilized, it searches for all SLC, network, and system input points and
automatically records them in the panel. This is used in conjunction with the following menus to
browse, program, edit, add, and remove all devices for easy customization of your system. If Auto
Program finds a new device(s), it will ask if you want to accept the device on the loop. If Auto Pro-
gram finds a device(s) missing when it scans, it will alert you to the absence and ask for your
acceptance. If, in either event, you do not choose to accept, a trouble will sound at reset, alerting
you to the situation.
Figure P-29
Figure P-30
Revision 1.0
Classic 2000 Mk II Operation Manual
Figure P-28
Part # MAN-Z3K-01
Figure P-31
Page 59
Advertisement
Table of Contents
