Set Port Speed; Get The Port Duplex Mode; Set The Port Duplex Mode; Set The Lockstate Of A Given Port - N-Tron 7014TX User Manual & Installation Manual

Set Port Speed

Command Name
Description
Syntax
Parameters
Examples
NOTES

Get the port duplex mode

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set the port duplex mode

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set the Lockstate of a given port

Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-21)
port set speed
Sets the port speed of a given port.
port set speed <port-no><speed>
port-no
Port number. (1 ~ 12)
speed
Speed of the port. Speed must either 10, 100, 1000 megabits per sec.
N-TRON/Admin#[1]> port set speed 5 10
N-TRON/Admin#[2]> port set speed 9 100
If the auto negotiation mode is enabled, port speed cannot be set. First
disable the auto negotiation mode, and then set the port speed.
port get duplexmode
Gets the port Duplex mode (FULL_DUPLEX / HALF_DUPLEX ) for a
given port number .
port get duplexmode <port-no>
port-no
Port number. (1 ~ 14)
N-TRON/Admin#[1]> port get duplexmode 4
Duplex mode of [4] port is: [half]
N-TRON/Admin#[2]> port get duplexmode 23
Duplex mode of [23] port is: [full]
Check whether port-no is in the valid range. (1 ~ 14)
port set duplexmode
Sets the port duplex mode (HALF_DUPLEX / FULL_DUPLEX) for a
given port number.
port set duplexmode <port-no> <full | half>
port-no
Port number. (1~12)
full | half
Duplex mode of the port. Duplex mode must be either
FULL_DUPLEX or HALF_DUPLEX.
N-TRON/Admin#[1]> port set duplexmode 4 full
N-TRON/Admin#[2]> port set duplexmode 4 half
Check whether port-no is in the valid range. (1 ~ 12)
port set lockstate
Sets the lock state of a given port to either enable or disable. If the port lock
is enabled, the switch can process the data packets only from locked MAC
addresses. Other data packets will not be processed.
port set lockstate <port-no> <enable | disable>
port-no
port number (1 ~ 14)
enable | disable
Lock enable or disable
N-TRON/Admin#[1]> port set lockstate 5 disable
N-TRON/Admin#[2]> port set lockstate 8 enable
Once the port is locked, all the MACs that are learned on that port are
treated as static MACs. This means the switch can process the packets
from those MACs only. It will discard all packets from other MACs.
Because the MAC is set for that port, it will only be addressable via that
port.
page 114 of 152