Administration - Snmp - N-Tron 7014TX User Manual & Installation Manual

Administration – SNMP
The SNMP tab under the administration category shows a list of IP Addresses that act as SNMP Traps. The
Get, Set, and Trap Community Names are also shown here.
By selecting the modify button you will be able to change any of the fields listed. This allows the user to set
an IP address for an SNMP Trap or change the Community Names. Systems that are listed as an SNMP
Trap will be sent basic networking changes made to the switch such as ports going down or being linked.
To restore a Trap to "Value Not Configured", enter „0.0.0.0‟.
(Revised 2011-07-21) page 26 of 152