N-Ring Related Commands; N-Ring Get Agingtime; N-Ring Set Agingtime; N-Ring Get Webfault - N-Tron 7014TX User Manual & Installation Manual

N-Ring Related Commands

N-Ring get agingtime

Command Name
Description
Syntax
Parameters
Example
NOTES

N-Ring set agingtime

Command Name
Description
Syntax
Parameters
Examples
NOTES

N-Ring get webfault

Command Name
Description
Syntax
Parameters
Example
NOTES

N-Ring set webfault

Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-21)
n-ring get agingtime
To display the N-Ring Agingtime of the device
n-ring get agingtime
None
N-TRON/Admin#[1]> n-ring get agingtime
N-Ring Aging Time :
Default: 20 seconds and is separate from the Bridging Aging Time.
N-Ring Aging time is used for the whole switch if the switch is an
N-Ring Manager or becomes an active N-Ring Member.
n-ring set agingtime
Sets the aging time for dynamically learned MAC addresses of the chipset
when in N-Ring Manager or Active N-Ring Member modes.
n-ring set agingtime <aging-time>
aging-time
aging time to be set for N-Ring.
Minimum N-Ring agingtime can be 5 seconds.
Default N-Ring aging time is 20 seconds.
Maximum aging time is 1000000 seconds.
N-TRON/Admin#[1]> n-ring set agingtime 200
Is separate from the Bridging Aging Time. N-Ring Aging time is used for
the whole switch if the switch is an N-Ring Manager or becomes an active
N-Ring Member.
n-ring get webfault
To display the browser N-Ring fault reporting mode.
n-ring get webfault
None
N-TRON/Admin#[1]> n-ring get webfault
N-Ring faults will be shown on N-Ring Web Pages only
n-ring set webfault
Sets the browser N-Ring fault reporting mode.
n-ring set webfault <ring|all>
Ring or all
N-TRON/Admin#[1]> n-ring set webfault all
N-Ring faults will be shown on All Web Pages
20
page 135 of 152