Port Manager Commands; Get The Link State Of A Given Port; Get Admin Status Of The Port; Set Admin Status Of A Port - N-Tron 7014TX User Manual & Installation Manual

Port Manager Commands

Get the link state of a given port

Command Name
Description
Syntax
Parameters
Examples
NOTES

Get admin status of the port

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set admin status of a port

Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-21)
port get linkstate
This command is used to get the present link state of a given port.
Whenever there is an active connection, link state (operational state) is
up; else link state is down.
port get linkstate <port-no>
port-no
Port number. (1 ~ 14).
N-TRON/Admin#[1]> port get linkstate 3
Link state of [3] port is: [down]
N-TRON/Admin#[2]> port get linkstate 1
Link state of [1] port is: [up]
Check whether port-no is in the valid range. (1 ~ 14)
port get adminstatus
This command is used to the get present adminstatus of a given port.
Adminstatus is used to enable or disable the port operations even though
there are active connections.
port get adminstatus <port-no>
port-no
Port number. (1 ~ 14).
N-TRON/Admin#[1]> port get adminstatus
Admin state of [4] port is: [enable]
N-TRON/Admin#[2]> port get adminstatus 9
Admin state of [9] port is: [disable]
Check whether port-no is in the valid range. (1 ~ 14)
port set adminstatus
This command is used to set the adminstatus of a given port to enable or
disable. If the adminstatus is disabled, the port cannot process the received
packets.
port set adminstatus <port-no><enable | disable>
1. port-no
Port number. (1 ~ 14).
2. adminstatus
adminstatus is either enable or disable.
N-TRON/Admin#[1]> port set adminstatus 4 enable
N-TRON/Admin#[2]> port set adminstatus 8 disable
Check whether port-no is in the valid range. (1 ~ 14)
4
page 112 of 152