Table of Contents
Advertisement
CLI Commands, Continued...
Show or Set Port Configuration
Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-11-15)
For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
Port
Show or set Port configuration.
port [-show] [-admin state] [-sd auto | 10h | 10f | 100h | 100f | 1000f]
[-flow state] [-fhp state] [-dp prio] [-dscp state] [-8021p state] [-pvid vid]
[-ual percent] [-uah percent] [-security state] portno
Portno
Port number to configure or show. Specify ―all‖ to show all ports.
-show
Show configuration.
-admin state
Set the admin status for the port to e(nabled) or d(isabled).
-sd
Set the speed and duplex mode for the port.
auto = enable auto-negotiation
-flow state
Set the flow control for the port to e(nabled) or d(isabled).
-fhp state
Set force high priority for the port to e(nabled) or d(isabled).
-dp
Set the default QOS priority for the port. The range is 0-7.
-dscp state
Set the DSCP Priority for the port to e(nabled) or d(isabled).
-8021p state
Set the 802.1p Priority for the port to e(nabled) or d(isabled).
-pvid
Set the VLAN ID for the port. The range is 1-4094.
-ual percent
Set the usage alarm low percentage. The range is 0-100.
-uah percent
Set the usage alarm high percentage. The range is 0-100.
-security state
Set the security status for all supported ports to e(nabled) or d(isabled).
N-TRON/Admin> port –sd 100f –flow enabled –dp 7 –pvid 2 5
Port Port
Admin
Link
Auto
No
Name
Status
Stat
Nego
---- ---- -------- ---- -------- ---- ---- -------- -------- --- ---------- ----
5 TX5
Enabled
Down Disabled
Changes have been made that have not been saved.
...
Port Dupl
Flow
Force
Spd
Mode Control
High Pri Pri
100 Full Enabled
Disabled
Def
Port
State
PVID
7 Disabled
2
Page 146 of 169
Advertisement
Table of Contents
