Set Flow Control; Set Name; Set Pvid; Set Backpressure - N-Tron 7014TX User Manual & Installation Manual

7014 series industrial gigabit ethernet switch
Table of Contents

Advertisement

Set Flow Control

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set Name

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set PVID

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set Backpressure

Command Name
Description
Syntax
Parameters
Examples
NOTES

Set Intruderstate

Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-21)
port set flowcontrol
Enable or Disable flow control (typically refers to 100Base). When
enabled a pause frame will be sent to help control the flow.
port set flowcontrol <port-no><enable | disable>
port-no
port number (1 ~ 12)
enable | disable
Flow Control enable or disable
N-TRON/Admin#[1]> port set flowcontrol 6 enable
Check whether port-no is in the valid range. (1 ~ 12)
port set name
Changes the name of the port. This change will only be visible in the CLI.
port set name <port-no><name>
port-no
port number (1 ~ 14)
name
A string that describes the port
N-TRON/Admin#[1]> port set name 6 waterplant
This will be reset if you change a slot configuration.
port set pvid
Set a port‟s VLAN-ID.
port set pvid <port-no><pvid-number>
port-no
port number (1 ~ 14)
pvid-number
The VLAN-ID number of the VLAN that this port will be a member of
N-TRON/Admin#[1]> port set pvid 6 2
A port can be a member to several VLANs, but can only have one PVID
port set backpressure
Enables or disables backpressure on a given port. This is normally used on
10Base setups and is a controlled by the hardware.
port set backpressure <port-no><enable | disable>
port-no
port number (1 ~ 12)
enable | disable
Backpressure enable or disable
N-TRON/Admin#[1]> port set backpressure 6 enable
Check whether port-no is in the valid range. (1 ~ 12)
port set intruderstate
Enables or Disables the intruder log.
port set intruderstate <enable | disable>
enable | disable
Enable or disable the intruder log
N-TRON/Admin#[1]> port set intruderstate enable
This must be enabled for the intruder log to log anything.
page 116 of 152

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7014fx27014fxe2

Table of Contents