Commands And Parameters; Mode Entry Commands; Fclass=1 - Select Facsimile Class 1 Mode; Fclass=1.0 - Select Facsimile Class 1.0 Mode - Conexant H08-15355F Reference Manual

<DLE><ETX> followed by OK result code to the DTE, and returns to command mode. If the modem detects a DTR drop while
&D3 is in effect, the modem performs a warm reset.

4.2 COMMANDS AND PARAMETERS

4.2.1 Mode Entry Commands

4.2.1.1 +FCLASS=1 - Select Facsimile Class 1 Mode

+FCLASS=1 selects the Fax Class 1Mode. The Fax Class 1 Mode commands and responses described in this section are
applicable when command +FCLASS=1 as shown Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)

4.2.1.2 +FCLASS=1.0 - Select Facsimile Class 1.0 Mode

+FCLASS=1.0 selects the Fax Class 1.0 Mode. The Fax Class 1.0 Mode commands and responses described in this section
are applicable when command +FCLASS=1.0 shown Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)

4.2.2 Mode Commands

4.2.2.1 +FAE - Auto Answer Enable

This command enables or disables fax adaptive answer.
Syntax
+FAE=<value>
Defined Values
<value> Decimal number corresponding to the selected option.

4.2.2.2 +FTS - Transmit Silence

This command causes the modem to terminate a transmission and wait for <time> 10-ms intervals before responding with the
OK result code.
Syntax
+FTS=<time>
Defined Values
<time> Decimal number from 0 (default) to 255 which specifies the length of time in 10-ms intervals to delay
before responding with the OK result code after terminating the session.
Result Codes
OK Reported when transmission has been terminated for the specified amount of time.
ERROR <value> is invalid or this command is issued while the modem is on-hook.
Reporting Supported Range of Parameter Values
Command: +FTS=?
Response: +FTS: <time> range
Example: +FTS: 0-255
4-4
Command Reference Manual
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem determines the calling type and
issues DATA result code (13) if the caller is a data modem or issues FAX result code
(15) if the caller is a fax modem.
Conexant
1118