O - Return To On-Line Data Mode; L - Speaker Volume - Conexant H08-15355F Reference Manual

3.2.3.6 O - Return to On-Line Data Mode

This command specifies that the modem will enter the on-line data mode from the on-line command mode with or without a
retrain. If in the off-line command mode when this command is entered, the modem reports ERROR.
Syntax
O[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
Result Codes
OK <value> = 0 or 1 and a connection exists.
ERROR Otherwise or no connection exists.

3.2.3.7 L - Speaker Volume

This command sets the speaker volume control according to the parameter supplied.
Syntax
L[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.
3-20
Command Reference Manual
0 Enters on-line data mode from the on-line command mode without a retrain. Handling is
determined by the Call Establishment task. Generally, if a connection exists, this
command connects the DTE back to the remote modem after an escape (+++).
1 Performs a retrain then enters on-line data mode from the on-line command mode.
0 Off.
1 Low volume. (Default.)
2 Medium volume.
3 High volume.
Conexant
1118