N - Automode Enable; V.8/V.8Bis Commands; A8E - V.8 And V.8Bis Operation Controls - Conexant H08-15355F Reference Manual

3.2.6.4 N - Automode Enable

This command is included for compatibility only and has no effect other than returning a result code. The only valid values are
0-1.
Syntax
N[<mode>]
Defined Values
<mode > Decimal number corresponding to the selected value: 0-1.
Result Codes
OK <mode> = 0 to 1.
ERROR Otherwise.

3.2.7 V.8/V.8bis Commands

3.2.7.1 +A8E - V.8 and V.8bis Operation Controls

This command is defined for two conditions: as a parameter while the modem is on-hook, and as an action command while
the modem is off-hook. If enabled, V.8 negotiation does not preclude simultaneous implementation of other negotiation
means (e.g., V.8bis, V.18, V.32bis Annex A).
This command is a compound parameter if issued while the modem is on-hook, used to precondition V.8 and V.8bis
originating and answering operation. It is issued by the DTE before the Dial (D) or Answer (A) command, regardless of the
state of the +FCLASS parameter.
This command is an action command if issued while the modem is off-hook, to (re)start V.8 or V.8bis negotiation. For
example, if initial V.8 negotiation failed, but subsequent T.30 negotiation indicated V.8 capability, this command may be used
to initiate V.8 negotiation.
Syntax
+A8E=<v8o>,<v8a>,<v8cf>[,<v8b>][,<cfrange>][,<protrange>]
Defined Values
Decimal number which enables/disables issuance of +A8 x indications during modem-controlled V.8
<v8o>
origination negotiation
<v8a>= Decimal number which enables/disables issuance of +A8 x indications during modem-controlled V.8
answer negotiation.
<v8cf>= Set the V.8 CI signal call function to the hexadecimal octet value X.
<v8b>= Decimal number which enables/disables V.8bis negotiation.
<cfrange>= "<string of values>". Applicable only for <v8a>=5 (not supported).
< protrange >= "<string of values>". Applicable only for <v8a>=5 (not supported).
Default values: 1,1,,1,"",""
1118
Command Reference Manual
1 Enable DCE-controlled V.8 origination negotiation without +A8x indications.
(Default.)
6 Enable DCE-controlled V.8 origination negotiation with +A8 x indications.
1 Enable DCE-controlled V.8 answer negotiation without +A8x indications. (Default.)
5 Enable DCE-controlled V.8 answer negotiation with +A8 x indications.
0 Disable V.8bis negotiation. (Default.)
1 Enable DCE-controlled V.8bis negotiation.
2 Enable DTE-controlled V.8bis negotiation.
Conexant
3-33