3.3 S-PARAMETERS
The supported S-Parameters are summarized in Table 3-13.
Register
S0
Number of Rings to Automatic Answer
S1
Ring Counter
S2
Escape Character
S3
Line Termination Character
S4
Response Formatting Character
S5
Command Line Editing Character
S6
Wait Time for Dial Tone Before Blind Dialing, or After "W" Dial Modifier
S7
Wait Time For Carrier After Dial, For Silence, or For Dial Tone After "W" Dial Modifier
S8
Pause Time for Dial Delay Modifier
S10
Carrier Loss Disconnect Time
S11
DTMF Tone Duration
S12
Escape Prompt Delay
S18
Test Timer
S29
Flash Dial Modifier Time
S30
Disconnect Inactivity Timer
S46
Data Compression Control
S95
Result Code Messages Control
3.3.1.1 AT=x - Write to Selected S-Parameter
This command writes the value x to the currently selected S-Parameter. An S-Parameter can be selected by using the ATSn
command. All of the S-Parameters will return the OK response if x is a number. Some registers may not be written due to
country specific PTT limitations.
Syntax
S=x
Result Codes
OK
For all arguments.
3.3.1.2 AT? - Read Selected S-Parameter
This command reads and displays the selected S-Parameter. An S-Parameter can be selected by using the ATSn command.
Syntax
S=?
Result Codes
OK
For all arguments.
1118
Command Reference Manual
Table 3-13. S-Parameter Summary
Function
Conexant
Units
rings
rings
ASCII
ASCII
ASCII
ASCII
s
s
s
0.1 s
0.001 s
0.02 s
s
10 ms
10 s
-
-
3-51