E - Enable/Disable Line Quality Monitor, Auto-Retrain, And Auto-Rate Renegotiation - Conexant H08-15355F Reference Manual

+MCR: Report Syntax
Response: +MCR: <carrier>
<carrier> Alphanumeric code corresponding to the reported carrier. Defined values are:
+MRR: Report Syntax
Response: +MRR: <tx_rate>,<rx_rate>
<tx_rate> Decimal transmit rate in bits/s.
<rx_rate> Decimal receive rate in bits/s.
Example: +MRR: 28800, 48000

3.2.4.3 %E - Enable/Disable Line Quality Monitor, Auto-Retrain, and Auto-Rate Renegotiation

This command controls whether or not the modem will automatically monitor the line quality and request a retrain (%E1) or a
rate renegotiation when line quality merits a change. If enabled, the modem attempts to retrain for a maximum of 30 seconds.
Syntax
%E[<value>]
Defined Values
<value> A decimal number corresponding to the selected option:
Result Code
OK <value> = 0 and 1
ERROR Otherwise.
3-26
Command Reference Manual
B103 For Bell 103
B212 For Bell 212
V21 For V.21
V22 For V.22
V22B For V.22bis
V23C For V.23
V32 For V.32
V32B For V.32bis
V34 For V.34
V90 For V.90
K56 For K56flex
0 Disable line quality monitor, auto-retrain, and auto-rate renegotiation.
1 Enable line quality monitor, auto-retrain, and auto-rate renegotiation. (Default.)
Conexant
1118