P - Select Pulse Dial Make/Break Ratio; V - Display Current Configuration And Stored Profile - Conexant H08-15355F Reference Manual

3.2.3.10 &P - Select Pulse Dial Make/Break Ratio
This command determines the make/break ratio used during pulse dialing. It is only effective if the appropriate bit to enable
this command is set through the .INF File. If enabled, it will override the make/break ratios in the OEM parameters in the .INF
File. The default is country-dependent.
Syntax
&P[<value>]
Defined Values
<value> Decimal number corresponding to the selected information.
Result Codes
OK <value> = 0 to 3.
ERROR Otherwise.
3.2.3.11 &V - Display Current Configuration and Stored Profile
This command reports the current (active) configuration and the stored (user) profiles.
Syntax
&V
Result Code
OK
Example:
AT&V
ACTIVE PROFILE:
E1 L1 M1 Q0 T V1 X0 &C1 &D2 &G0 &T0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:004 S07:050 S08:004
S10:014 S12:050 S16:000 S18:000 S29:070
STORED PROFILE 0:
E1 L1 M1 Q0 T V1 X4 &C1 &D2 &G0 &T0
S00:000 S02:043 S06:004 S07:050 S08:004 S10:014 S12:050 S18:000 S29:070
OK
3-22
Command Reference Manual
0 Selects 39%-61% make/break ratio at 10 pulses per second. (Default.)
1 Selects 33%-67% make/break ratio at 10 pulses per second.
2 Selects 39%-61% make/break ratio at 20 pulses per second.
3 Selects 33%-67% make/break ratio at 20 pulses per second.
Conexant
1118