W - Store Current Configuration; B - Display Blacklisted Numbers; D - Display Delayed Numbers - Conexant H08-15355F Reference Manual

3.2.3.12 &W - Store Current Configuration
This command saves the current (active) configuration (profile), including S-Parameters, in the Registry. The current
configuration is comprised of a list of storable parameters illustrated in the &V command. These settings are restored to the
active configuration upon receiving an Z command or at power up.
Syntax
&W
Result Code
OK

3.2.3.13 *B - Display Blacklisted Numbers

This command requests the modem to return a list of blacklisted numbers to the DTE. The format of the response is shown by
the example below. Permanently forbidden numbers as defined by country requirements will not appear on this list. If no
numbers are blacklisted, only the OK result code is issued.
Example:

3.2.3.14 *D - Display Delayed Numbers

This command causes the modem to send a list of the delayed numbers together with the delay associated with each. The
modem will return a list of delayed telephone numbers as defined in the *B command. The format of the response is shown by
the example below (delay times are shown as hours:minutes:seconds). If no numbers are delayed, only the OK result code is
issued.
Example:
1118
Command Reference Manual
NO. - PHONE NUMBER -
------ ------------------------------
1; 4175537660
2; 8288924961
3; 3887278862
4; 3124839442
5; 6284664
OK
NO. - PHONE NUMBER -DELAY
------ -------------------------------------------
1; 8264734660 2:00:00
2; 7532634661 2:00:00
3; 2587334662 0:02:00
4; 7532651663 0:03:25
5; 7459931664 0:01:45
OK
Conexant
3-23