Esr - Selective Repeat; Efcs - 32-Bit Frame Check Sequence; Er - Error Control Reporting - Conexant H08-15355F Reference Manual

3.2.5.3 +ESR - Selective Repeat

This extended-format numeric parameter controls the use of the selective repeat (SREJ) option in V.42.
Syntax
+ESR=[<value>] Decimal number 0 specifying that SREJ is not used.
Example:
+ESR: (0) For default settings.

3.2.5.4 +EFCS - 32-bit Frame Check Sequence

This extended-format numeric parameter controls the use of the 16-bit or 32-bit frame check sequence (FCS) option in V.42.
Syntax
+EFCS=[<value>]
Defined Values
<value> Decimal number 0 specifying the use of the 16-bit FCS specified in V.42.
Reporting Current or Selected Values
Command: +EFCS?
Response: +EFCS: <value>
Example: +EFCS: 0
Reporting Supported Range of Parameter Values
Command: +EFCS=?
Response: +EFCS: (<value> range)
Example: +EFCS: (0)

3.2.5.5 +ER - Error Control Reporting

This extended-format numeric parameter controls whether or not the extended-format "+ER: " intermediate result code is
transmitted from the modem to the DTE (see Section 3.5 and Table 3-14).
S95 bit 3 is reset to 0 for +ER=0 and is set to a 1 for +ER=1. The more recent setting of +ER or S95 bit 3, and the W
command setting, determines the actual error control result code reporting (see S95 Parameter and W Command).
+ER=[<value>]
Syntax
+ER=[<value>]
Defined Values
<value> A decimal number corresponding to the selected error control option:
Reporting Current or Selected Values
Command: +ER?
Response: +ER: <current value>
Example: +ER: 1
Reporting Supported Range of Parameter Values
Command: +ER=?
Response: +ER: (<value> range)
Example: +ER: (0,1)
1118
Command Reference Manual
For default setting.
0 Error control reporting disabled (no +ER intermediate result code transmitted).
1 Error control reporting enabled (+ER intermediate result code transmitted). (Default.)
for the default setting
Conexant
3-29