Vdr - Distinctive Ring - Conexant H08-15355F Reference Manual

5.2.2.15 +VDR - Distinctive Ring

This command causes the modem to enable or disable reporting of the ring cadence information and to control the timing of
the RING event code report if ring cadence reporting is enabled.
Syntax
+VDR=<enable>, <report>
Defined Values
<enable> Decimal number corresponding to the selected option.
<report> Decimal number specifying ring cadence information report when enabled by the <enable>
subparameter.
Reporting Current or Selected Values
Command: +VDR?
Response: +VDR: <enable>,<report>
Example: +VDR: 0,0
Reporting Supported Range of Parameter Values
Command: +VDR=?
Response: +VDR: (<enable> range),(<report>range)
Example: +VDR: (0,1),(0-60)
Result Codes
OK <enable>,<report> = (0,1),(0-60)
ERROR Otherwise, or if not in Voice Mode.
5-16
Command Reference Manual
0 The modem will not report ring cadence information.
1 The modem will report ring cadence information as specified for the <report>
subparameter.
0 The modem will produce only DROF and DRON messages. The modem will not
produce any RING event codes. The modem will report other call progress event codes
as normal.
Other The modem will produce only DROF and DRON messages. The modem will produce a
RING event code after <report>/10 seconds after the falling edge of the ring pulse (i.e.,
after the DRON report).
For the default setting.
Conexant
1118