Firmware Upgrade Screen - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 25 Tools
Note that the telnet connection must be active before and during the TFTP
transfer. For details on TFTP commands (see following example), please consult
the documentation of your TFTP client program. For UNIX, use "get" to transfer
from the ZyXEL Device to the computer and "binary" to set binary transfer mode.
TFTP Command Configuration Backup Example
The following is an example TFTP command:
tftp [-i] host get rom-0 config.rom
where "i" specifies binary image transfer mode (use this mode when transferring
binary files), "host" is the ZyXEL Device IP address, "get" transfers the file source
on the ZyXEL Device (rom-0, name of the configuration file on the ZyXEL Device)
to the file destination on the computer and renames it config.rom.
Configuration Backup Using GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based
TFTP clients.
Table 152 General Commands for GUI-based TFTP Clients
COMMAN
D
Host
Send/
Fetch
Local File
Remote
File
Binary
Abort
Refer to
TFTP and FTP over WAN.

25.2 Firmware Upgrade Screen

Click Maintenance > Tools to open the Firmware screen. Follow the
instructions in this screen to upload firmware to your ZyXEL Device. The upload
process uses HTTP (Hypertext Transfer Protocol) and may take up to two minutes.
After a successful upload, the system will reboot. See
upgrading firmware using FTP/TFTP commands.
422
DESCRIPTION
Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device's
default IP address when shipped.
Use "Send" to upload the file to the ZyXEL Device and "Fetch" to back up the
file on your computer.
Enter the path and name of the firmware file (*.bin extension) or
configuration file (*.rom extension) on your computer.
This is the filename on the ZyXEL Device. The filename for the firmware is
"ras" and for the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
Section 25.1.2 on page 415 to read about configurations that disallow
Section on page 418
P-2612HW-F1 User's Guide
for