Table of Contents
Advertisement
Clicking the Apply or Add button does NOT save the changes permanently.
All unsaved changes are erased after you reboot the ONU.
26.5 Reboot System
Reboot System allows you to restart the ONU without physically turning the power off. The
ONU loads configuration one (Config 1) when you reboot. Follow the steps below to reboot
the ONU.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to reboot
and load configuration one. The following screen displays.
Figure 107 Reboot System: Confirmation
2 Click OK again and then wait for the ONU to restart. This takes up to two minutes. This
does not affect the ONU's configuration.
26.6 Firmware Upgrade
Make sure you have downloaded (and unzipped) the correct model firmware and version to
your computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong model
firmware may damage your device.
From the Maintenance screen, display the Firmware Upgrade screen as shown next.
Figure 108 Management > Maintenance > Firmware Upgrade
ONU User's Guide
Chapter 26 Maintenance
195
Advertisement
Table of Contents
