Chapter 6 Maintenance; Overview; Administration Screen; Firmware Screen - ZyXEL Communications PMG1005-T20B User Manual

6.1 Overview

• Use the Administration screen to change your GPON Device's password
• Use the Firmware screen to upload firmware to your GPON Device
• Use the SysRestart screen to backup/restore or reboot the GPON Device without turning the power off
(Section 6.4 on page

6.2 Administration Screen

Use this screen to configure the GPON Device's password. Click Maintenance > Administration to open
the Administration screen.
Figure 12 Maintenance > Administration
The following table describes the labels in this screen.
Table 9 Maintenance > Administration
LABEL
New Password
Confirm Password
SAVE
CANCEL

6.3 Firmware Screen

Use the instructions in this screen to back up (save) the GPON Device's configuration file or upgrade its
firmware. After you configure your GPON Device, you can backup the configuration file to a computer.
24).
DESCRIPTION
Type your new system password (up to 30 characters). Note that as you type a password, the
screen displays a (*) for each character you type. After you change the password, use the
new password to access the GPON Device.
Type the new password again for confirmation.
Click SAVE to save your changes back to the GPON Device.
Click CANCEL to begin configuring this screen afresh.
PMG1005-T20B User's Guide
C
H A P T E R
Maintenance
22
(Section 6.2 on page
(Section 6.3 on page 22).
6
22).