ZyXEL Communications P-2612HW-F1 User Manual page 420

Chapter 25 Tools
Using the FTP Commands to Back Up Configuration
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your ZyXEL Device.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "get" to transfer files from the ZyXEL Device to the computer, for example,
6
"get rom-0 config.rom" transfers the configuration file on the ZyXEL Device to
your computer and renames it "config.rom". See earlier in this chapter for more
information on filename conventions.
Enter "quit" to exit the ftp prompt.
7
FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command
prompt to save your device's configuration onto your computer.
Figure 229 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
420
P-2612HW-F1 User's Guide