Wps - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 8 Wireless LAN
Table 32 Network > Wireless LAN > MAC Filter
LABEL
MAC
Address
Apply
Cancel

8.5 WPS

Use this screen to configure WiFi Protected Setup (WPS) on your ZyXEL Device.
WPS allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. Set up each WPS connection
between two devices. Both devices must support WPS. See
509 for more information about WPS.
Click Network > Wireless LAN >WPS. The following screen displays.
Figure 87 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 33 Network > Wireless LAN > WPS
LABEL
WPS Setup
Enable WPS
PIN Number
154
DESCRIPTION
Enter the MAC addresses of the wireless devices that are allowed or denied
access to the ZyXEL Device in these address fields. Enter the MAC
addresses in a valid MAC address format, that is, six hexadecimal character
pairs, for example, 12:34:56:78:9a:bc.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select the check box to activate WPS on the ZyXEL Device.
This shows the PIN (Personal Identification Number) of the ZyXEL
Device. Enter this PIN in the configuration utility of the device you want
to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Appendix D on page
P-2612HW-F1 User's Guide