Zyxel Device Access And Login - ZyXEL Communications P-2612HW-F1 User Manual

Chapter 27 Troubleshooting
Make sure you understand the normal behavior of the LED. See
1
page 28.
Check the hardware connections. See the Quick Start Guide.
2
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Turn the ZyXEL Device off and on.
4
If the problem continues, contact the vendor.
5

27.3 ZyXEL Device Access and Login

I forgot the IP address for the ZyXEL Device.
The default IP address is 192.168.1.1.
1
If you changed the IP address and have forgotten it, you might get the IP address
2
of the ZyXEL Device by looking up the IP address of the default gateway for your
computer. To do this in most Windows computers, click Start > Run, enter cmd,
and then enter ipconfig. The IP address of the Default Gateway might be the IP
address of the ZyXEL Device (it depends on the network), so enter this IP address
in your Internet browser.
If this does not work, you have to reset the device to its factory defaults. See
3
Section 1.5 on page
I cannot see or access the Login screen in the web configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
Check the hardware connections, and make sure the LEDs are behaving as
2
expected. See the Quick Start Guide.
440
30.
(Section on page
I forgot the IP address for the ZyXEL Device.
Section 1.4 on
133), use the new IP
P-2612HW-F1 User's Guide