Configuring Firewall Rules - ZyXEL Communications P-2612HW-F1 User Manual

Table 68 Security > Firewall > Rules (continued)
LABEL
Source IP
Destination IP This drop-down list box displays the destination addresses or ranges of
Service
Action
Schedule
Log
Modify
Order
Apply
Cancel

12.3.1 Configuring Firewall Rules

Refer to Section 12.1.2 on page 232
P-2612HW-F1 User's Guide
DESCRIPTION
This drop-down list box displays the source addresses or ranges of
addresses to which this firewall rule applies. Please note that a blank
source or destination address is equivalent to Any.
addresses to which this firewall rule applies. Please note that a blank
source or destination address is equivalent to Any.
This drop-down list box displays the services to which this firewall rule
applies. See Appendix E on page 533
This field displays whether the firewall silently discards packets (Drop),
discards packets and sends a TCP reset packet or an ICMP destination-
unreachable message to the sender (Reject) or allows the passage of
packets (Permit).
This field tells you whether a schedule is specified (Yes) or not (No).
This field shows you whether a log is created when packets match this
rule (Yes) or not (No).
Click the Edit icon to go to the screen where you can edit the rule.
Click the Remove icon to delete an existing firewall rule. A window
displays asking you to confirm that you want to delete the firewall rule.
Note that subsequent firewall rules move up by one when you take this
action.
Click the Move icon to display the Move the rule to field. Type a number
in the Move the rule to field and click the Move button to move the rule
to the number that you typed. The ordering of your rules is important as
they are applied in order of their numbering.
Click this to save your changes.
Click this to restore your previously saved settings.
for more information.
for more information.
Chapter 12 Firewall
239