Response Message Button - Comdial DXP, DXP Plus, FX Attendant Manual

GCA70250
8. SELECT SAVE.
9. PRESS SPEAKER to quit.
When an alert sounds at the set time, you hear four short tone bursts,
which will continue until acted upon. If you are not at your station to
hear the alert when it sounds, your telephone's ring tone changes to
the alert tone for every incoming call until you respond to the alert.
• To respond to an alert after it
sounds, choose one of the
following:
1. SELECT CLEAR to turn off the
alert.
2. SELECT SET to reset the alert for
the same time the following day.

6.6 Response Message Button

You may program a RESPONSE MESSAGE button, which allows
you to send an LCD message to a caller who has initiated a SOHVA
or intercom call from another LCD speakerphone, or to send an LCD
message to another LCD speakerphone that you call and receive a
busy signal or no answer.
• To store a scrolling RESPONSE MESSAGE button, proceed
as follows (user may press button repeatedly to choose from
up to 30 system supplied messages),
1. PRESS INTERCOM.
2. DIAL **6.
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL 00.
5. DIAL # to save programming.
6. PRESS SPEAKER to end.
7. LABEL button location.
August, 03 Comdial
Attendant Manual
ALERT 1 10:30 AM
SET
Responding to an Alert
CLEAR
75